Setting of cutter die height of the cutting machine

1》 Remove the sundries on the rubber plate of the work table and place the knife mold in the center of the rubber plate.
2》 After the machine starts, loosen the set handwheel and turn the "pressure control" to the zero position.
3》 Turn the setting switch right to the "knife mold setting" direction, and the cutting pressure plate 13 will start to slowly descend until it is close to the knife mold and then stop automatically.
4》 Push the setting handwheel to the bottom and tighten it. Turn the 04 setting switch (left rotation) to the "cutting" position before starting.
5》 Then press the brake switch, and the cutting pressure plate will immediately rise to the highest position. At this time, the tool mold is set.